SKU:
BDS124022
UPC:
7.11746E+11
BDS124022 will eliminate a common weak link on your Jeep by upgrading the shock mounts with BDS bar pin eliminators. The standard bar pin design used by most manufacturers provides no lateral support of the shock absorber bushings. Excessive movement between the parts causes the bushings to distort instead of deflecting impacts to the shock absorber as intended. As the bushings lose their integrity annoying "thumping" or "rattling" sounds are often heard and even felt inside the vehicle cabin. This solution provides a heavy duty cross pin and mount blocks to convert the shock mounting to a standard EB1 eyelet. The design prevents the transfer of noise and vibration caused by bushing movement. Shock absorber bushings are preloaded for better performance and longevity. Machined bushing surfaces reduce friction and wear. Retains the original mounting alignment to prevent stress on shock absorber and bushing. Provides almost 1/2 in. of additional down travel at shock absorber. Manufactured from premium grade steel and Zinc-coated for corrosion resistance. Compatible with OE and aftermarket shock absorbers.Tapered and roll-pointed leafs add flexibility and provide an even deflection rate Increased wheel travel and a softer ride from tapering allow smoother transition between leafs as compression takes place Higher articulation from bolt-style leaf alignment clamps prevents leafs from fanning out allowing leafs to twist and flex Multi-leaf progressive design for smooth ride Anti-friction pads provide a smooth and quiet ride Installation Time: 1 Hr Pvg Product Status: Active
Features-
Details-
Wearable Parts - Limited Lifetime Warranty
BDS NX2 Series Shocks and BDS/Fox Performance Series Shocks:
Shock oil seals are not covered by this Limited Lifetime Warranty because they are subject to wear over time and use. At BDS's discretion, leaking shock seals less than 2 years from date of purchase, free from contamination, damage, or abnormal seal wear due to misuse can be considered for repair or replacement under warranty. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion.
Fox Proprietary Shocks and Coil Overs:
Fox Proprietary parts are covered by their warranty and are not included in the BDS Warranty. BDS may offer to assist with the warranty of defective product, at our discretion. Other warranty concerns should be handled through the Fox Service program. Leaking shock seals less than 1 year from date of purchase, free from contamination, damage, or abnormal seal wear due to misuse can be considered for Warranty. FOX service information can be
found here: https://www.ridefox.com/service.php?m=truck
Ball Joints and Tie Rod Ends:
These items are subject to normal wear over time. However, Ball Joints and Tie Rod ends less than 3 years from the date of purchase, that have been properly greased, maintained, and do not show signs of abnormal use can be considered for warranty.
BDS Suspension's obligation under all warranties is limited to the repair or replacement, at BDS's option, of the defective material. BDS will cover the cost of ground shipping on warranty items, and a return shipping label if we require the warranty part to be returned to us. Any cost of removal, installation or reinstallation, expedited freight charges, incidental or consequential damages are expressly excluded from these warranties. Proof of purchase is required for all warranty claims.
